2012年8月31日星期五

Toyota Prado Installation Manual

Toyota Prado Installation Manual
 

Toyota Prado Installation Manual
Precautions
1. Only the professional installing technicians are allowed to install and maintain this product.
2. Installation or maintenance by the unprofessional people might cause electric shoke or other risks and even damage the unit.
3. In the process of connecting, pay attention to the hook position, don't pull wires forcibly to avoid invalid connection.
4. Please use the attached wire of the system, otherwise the accident of fire or smoke or damage to the unit or vehicle might be caused.
5. Don't cut off any extra wire which is kept for future use, Protect the ends of wire with insulating tape.
6. In order to avoid short circuit, please disconnect the anode of the power accumulator before any connection and installation.
7. Ensure all lines are placed and protected in good condition, don't let them interfere in any moveable parts of the car such as steering wheel, gearlever, brake pedal, sliding chair, door or other parts.
8. The voice is input through AUX, so please ensure audio cable connectes well with the AUX port of the original car audio system.

1. Before installation
2. Remove the air-condition button panel,please note the clips
3. Remove the decorate dash around the original unit.
4. Remove the screws and take out the original unit (Please keep the screws to fix the DVD host)
5. Take apart the side trim of the small storage box.
6. Remove the small trim under the storage box and then remove the storage box.
7. The center console after removing the original stereo unit
8. Remove the buttons and clips on the original frame, take apart the air-conditioner outlet .
9. The components from the original frame
10. Put the components to the corresponding place on the navigation screen part (navigation system)
11. The navigation screen part (navigation system) with original components
12. Fix the original brackets from the original unit

13. Put the transfer harnesses in position through the centre console
14.Connect the harness with the monitor.(The USB cable should be fished of through the dash)
15. Install the monitor in the right position.
16. plug the harnesses at the back panel of DVD part

17. Tighten the DVD part with the screws you removed. Connect the cables on the back panel of the storage box and install it
18. Reassemble the grey side trim
19. Put the original conditioner panel back with all cables connected
20. Installation finished

0 评论:

Most popular post last week:

Car GPS Navigation Wholesale