2012年1月4日星期三

Hot ways to Wire the Radio in a Mazda Millenia--The five Steps

The Mazda Millenia was produced from 1995-2002. As it was originally intended to be a luxury-branded car rather than a typical Mazda, it featured upscale leather, wood and chrome appointments inside, along with higher-quality paint and better overall fit and finish.

2001.mazda millenia
2001 mazda millenia
to wire the radio in your Mazda Millenia is fairly simple and there is only one wiring connector to install to the radio. One of the crucial steps is removing the radio to access the wiring component. You should konw some information about the radio structure that the radio in your Millenia is held in by four locking tabs. Once those tabs are released, you can pull the radio out to repair, replace or simply rewire it. It takes no more to complete wiring procedure.
Procedure:
1   Use a flat-head screwdriver to pry off the two plastic tabs from the front of the car radio. This will reveal four small holes.
2   Insert a Phillips-head screwdriver into each of the four holes and press in until you hear a click. This will release the locking tabs.
3   Pull the radio out toward you. If the radio does not come out, make sure that you have released all of the tabs.
4   Reach behind the radio to locate the wiring connector. Securely plug the wiring connector into the rear of the radio.
5   Push the radio back into its initial position. Make sure you push it in all the way so that the locking tabs secure the radio into place. Reattach the two plastic tabs.

0 评论:

Most popular post last week:

Car GPS Navigation Wholesale